The Haiyang Stream Mod

[audioactive08]

Beta v.101507

Parts and Cost

1" female adapter - 15
1"x1" pvc pipe - 0
metal rod from an old umbrella - 0
Haiyang 600 lp/h - 230
Old syringe - 0
Superglue - 15
Old suction cups - 0
Casing from a wristwatch - 0

Tools

Drill and drill bit/s
pliers
scissors
a sharp knife
a candle / stove


Procedures:




a. Shroud

Glue the pipe and the adapter
Drill the shroud



b. Propeller

Heat the stock impeller and slightly bend it to an angle you desire.
Cut both ends of the syringe.
Cut the impeller in half
Glue the syringe and the impeller together, as shown in the photo.

c. Rod

Cut the rod from the umbrella using a plier.
Assemble the parts together.

Wattage: 8.5 watts
Cost: around 260 pesos
Estimated Output: Roughly the same output as with Seio m620. (still need to build a better propeller.)
Dimensions: (+/-) 1.5" x 2.25" x 5"

video:
http://s18.photobucket.com/albums/b138/ ... 7_0004.flv

[mikedown]

[audioactive08]

thanks! actually, i installed the airhose just to show the output of the pump. pag wala na yung hose, wala na ring bubbles.

the powerhead is shaky due to the flimsy plastic holder, i wonder how much would it cost to buy an acrylic version? (paging sir wiley..)

since there are no cheap propellers available here, i'll make one myself.

cheers!

[wgtan]

[CLYVZ]

[audioactive08]

[lombard0]

[audioactive08]

thanks chief. the mod still need some tweaking though.

wgtan> sir, here's my idea of the mount and bracket.



the bracket is similar to the seio bracket, as shown here:







while the mount is kinda similar to this:

[obet_carlos]

nice DIY..
how did you attach the powerhead sa mount? nakapatong lang? hindi ba mahuhulog pag matabig ng isda? napansin ko lang..

[wgtan]

[audioactive08]